Removing (Left) Oil Mist Separator
WARNING: This page is about a different variant/trim than selected.
- Press release button on both sides on both adapters -2-
and disconnect vacuum hoses -1-
on the (left) oil mist separator.
Loosening adapters on the (left) oil mist separator
- Remove oil mist separator -1-
.
- 2.1 Press heat shield aside until screws -2, 4 and 6-
on the (left) oil mist separator -1-
are accessible.
Information
Screws on the oil separator are permanently connected. If screws are damaged, press the screws out of the oil separator and replace them.
- 2.2 Loosen screws -2 to 7- .
- 2.3 Remove (left) oil mist separator -1- .
Removing (left) oil mist separator
- 2.1 Press heat shield aside until screws -2, 4 and 6-
on the (left) oil mist separator -1-
are accessible.