Installing Oil Pump
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1 Fit new seal on oil pump.
- 1.2 Replace screws for oil pump and screw for sprocket at the oil pump.
- 1.3 Tighten screws for oil pump to > Initial tightening 8 Nm (6 ftlb.) > Final tightening + 90° .
- 1.4 Tighten screw securing sprocket to oil pump to > Initial tightening 20 Nm (15 ftlb.) and > Final tightening + 90° .