Installing Radiator

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Installation is performed in reverse order. Pay particular attention to the following:
Check rubber mountings -1 and 2- for damage and replace them if necessary.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rubber mount

Tightening torque for screws securing condenser retaining frame to radiator: > Tightening torque 5 Nm (3.7 ftlb.)

Tightening torque for screws securing coolant distributor tubes to radiator: > Tightening torque 9 Nm (6.5 ftlb.)

Tightening torque for clamp securing pressure hose to charge-air cooler: > Tightening torque 5.5 Nm (4 ftlb.) +/- 0.5 Nm (0.3 ftlb.)