Filling Device - Overview And Setup
WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Components of vacuum-filling device
| 2 | Hose extension FZ 100 (install between K65 and KVB 01) |
| 3 | KVB 01 (Vacuum gauge with two shut-off valves) > 9696 - Filling device |
| 4 | Venturi nozzle for creating a vacuum. A minimum pressure of 8 bar must be available. |
| 5 | Filler hose (The cooling system is refilled via this hose) |
| 6 | Return lines (The compressed air and extracted coolant are drawn off via this hose) |
| V1 | Shut-off valve V1 (Shut-off valve for filler hose) |
| -V2- | Shut-off valve V2 (Shut-off valve for filler hose - outlet to Venturi nozzle) |
Illustration of vacuum-filling device setup
| 1 | Return lines |
| 2 | Overflow container (bucket or canister) |
| 3 | Compressed air connection |
| 4 | Make sure the compressed air connection has a minimum pressure of 8 bar. |
| 5 | Filling canister with coolant (Position at the same height as the reservoir to make filling easier) |
| 6 | Fit adapter K 65 with extension FZ 100 instead of the cap. |
| 7 | KVB 01 (Vacuum gauge with two shut-off valves V1 and V2) |
| V1 | Shut-off valve V1 (Shut-off valve for filler hose) |
| -V2- | Shut-off valve V2 (Shut-off valve for filler hose - outlet to Venturi nozzle.) |