LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2022 >> Panamera Base >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 21 Exhaust Gas Turbocharging 2.9L Turbo Gas -- 971 - PANAMERA (971) >> WM, 213919 Removing And Installing Pressure Hose (V6 BITURBO) >> Installing Pressure Hose >> Installing Moulded Hose

Installing Moulded Hose

  1. Install moulded hose -1-  from charge-air cooler to intake distributor.
    1. 1.1 Tighten screw-type -Arrows-  clamps to > Tightening torque 5.5 Nm (4 ftlb.) +/- 0.5 Nm (0.3 ftlb.)  .
    G15877341Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Moulded hose from turbocharger to intake distributor (right illustration)

scientia non olet · About LEMON Manuals