Removing (Outer) Rear Wheel Housing

Fig 1: Rear Wheel Housing Component Location (Outer)

Installation position of (outer) rear wheel housing

1. Roughly cut out (outer) rear wheel housing.

   Roughly cutting out rear wheel housing

2. Remove remaining piece at the rear.

Removing remaining piece at the rear

1. 2.1 Drill through clinch points using a drill bit with a diameter of > Diameter 6.6 mm  .

   Information 

   Only make cuts in the top plate. Make sure not to damage the plate underneath when doing this.

2. 2.2 Make a cut at the marked position.
3. 2.3 Remove remaining sheetmetal strip.