Install (Outer) Wheel Housing Rear
Information
- Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
- The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
- Do not begin bonding work until all materials and tools necessary for later repair work are available.
- Install (outer) wheel housing rear and check that it fits perfectly.
- Remove (outer) wheel housing rear.
- Apply adhesive on the joint area of the body.
Bonding areas
Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm
Working with body structural adhesive
- Apply adhesive on the joint area of the body.
Bonding areas
Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm
Working with body structural adhesive
- Apply adhesive to (outer) wheel housing rear.
Bonding areas
Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm
- 5.1 Also apply a bead of adhesive all around the bonding surface. > Application depth 3 mm
- Rivet in (outer) wheel housing rear. > BLIND RIVET 999.190.229.01
Riveting in (outer) wheel housing rear