Removing Rear Wheel Housing (Inner Section)

Fig 1: Wheel Housing Rear Component Location (Inner Section)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installation position

1. Drill out spotwelds.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Spotwelds

2. Drill out penetrated joints.

   > 5X00IN23 REPLACING PUNCH RIVETS AND PENETRATED JOINTS

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Penetrated joints

3. Separate welded seams.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Welded seams

4. Set cut at the marked position -dimension A-  .

   > Distance 85 mm 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Cut

5. Heat bonding areas -A, B and C-  using > V.A.G 1416 - Hot-Air Blower  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bonding areas

6. Remove (inner) rear wheel housing section.