Preparing Connection Areas Of Body For Installing Centre Side Member

Information 

• Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive. 
• The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed. 
• Do not begin bonding work until all materials and tools necessary for later repair work are available. 

1. Align the sealing surfaces and connections of the body.
2. De-burr connection areas and prepare for joining.
3. -marked areas-  must be prepared for bonding.

   > 5X00IN21 Working with body structural adhesive

Preparing connection areas of body for installing centre side member