Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Screws | Heat shield to drive shaft | Tightening torque | 23 Nm (17 ftlb.) | ||
| Drive shaft to wheel hub | 1st step (wheels suspended in air, press brake while tightening)/M1 6 x 72 thread/always use new screws following removal | Tightening torque | 200 Nm (148 ftlb.) | ||
| Drive shaft to wheel hub | 2nd step (wheels on the ground)/M16 x 72 thread/always use new screws following removal | Torque angle | 180° | ||
| Drive shaft to transmission | M10 x 20 thread/always use new screws following removal | Initial tightening | 30 Nm (22 ftlb.) | ||
| Drive shaft to transmission | M10 x 20 thread/always use new screws following removal | Final tightening | + 90° | ||
| Fastening screws | Heat shield to frontaxle carrier | Tightening torque | 9 Nm (6.5 ftlb.) | ||
| Fastening screw | Heat shield to frontaxle carrier | Tightening torque | 20 Nm (15 ftlb.) |