General Information

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

NOTIFICATION

Air springs can become kinked/fall out

Risk of damage to air springs
→ Deactivate the levelling system before raising the vehicle.

→ Check the bellows before lowering the vehicle.

Information

Always pay particular attention to the following before raising the vehicle:

The levelling system must be deactivated before raising the vehicle (press and hold the levelling system button for at least 10 seconds).
If a transmission range will be engaged while the vehicle is raised, the levelling system must be deactivated beforehand using the PIWIS Tester. To do this, select >>Levelling system/PASM<<>>Drive links/checks<<>>Activate/deactivate levelling system (without wheel rotation detection)<< in the control unit overview. Select the value "Deactivate levelling system (permanently)" and press "Start" F8 to execute the function. Re-activate the levelling system when the work is complete. To do this, select >>Drive links/checks<<>>Conclude initial commissioning>> and then select "Activate levelling system" under >>Activate/deactivate levelling system (without wheel rotation detection)<< and execute the function by pressing "Start" F8.
All functions (e.g. bleeding/filling) of the PASM control unit are deactivated as soon as the levelling system has been deactivated using the function >>Activate/deactivate levelling system (without wheel rotation detection)<<.