Installing Connecting Link For Anti-Roll Bar
WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1 Replace screw and nut securing connecting link for anti-roll bar to anti-roll bar.
- 1.2 Tighten screw and nut securing connecting link for anti-roll bar to anti-roll bar.
> Initial - tightening 50 Nm (37 ftlb.)
> Final tightening + 90°
- 1.3 Replace screw securing connecting link for anti-roll bar to lower trailing arm.
- 1.4 Tighten screw securing connecting link for anti-roll bar to lower trailing arm.
> Initial - tightening 50 Nm (37 ftlb.)
> Final tightening + 90°