LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2022 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (37 Automatic Transmission - Actuator, Housing 3.0L -- 95B - MACAN (95B)) >> WM, 371319 Removing And Installing Locking Cable >> Removing Locking Cable

Removing Locking Cable

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information 

Do not apply lateral forces to the selector knob pull rod as it can break off.

  1. Remove switch console holder -1-  .
    G15152745Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Switch console holder

    1. 1.1  Release and remove switch console holder -1-  in -direction of arrow-  .
  2. Remove insulating mat -1-  .
    G15152746Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Insulating mat

    1. 2.1  Release and disconnect cable plug -2-  .
    2. 2.2  Remove insulating mat

      Information 

      • Loosen clamping screw for locking cable by only about 1 turn. 
      • The clamping screw is only accessible in selector-lever position "P". 
      • When the clamping screw is loosened, the selector lever must remain in position "P". 
  3. Loosen clamping screw for locking cable by about 1 turn -1-  using > T40031 - socket insert a/f 5-2-  .
    G15152747Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Clamping screw for locking cable

  4. Loosen transmission support -2-  .
    G15152748Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Transmission support

    1. 4.1  Support transmission at transmission support -2-  using > VAS 6931 - engine and gearbox jack  .
      1. 4.1.1  Place a suitable piece of wood under the > VAS 6931 - engine and gearbox jack  and position it under the transmission support so that the screws -1 and 3-  are accessible.
    2. 4.2  Unscrew screws -1 and 3-  .
    3. 4.3  Lower the transmission approx. 25 mm using > VAS 6931 - engine and gearbox jack  .
  5. Remove heat shield
    G15152749Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Heat shield

    1. 5.1  Loosen clamping washers -2-  .
    2. 5.2  Remove heat shield -1-  .
  6. Disconnect locking cable -1-  from selector support -3- 
    G15152750Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Locking cable on selector support

    1. 6.1  Loosen the safety clip -2-  and pull locking cable -1-  out of the selector support -3-  .
  7. Remove locking cable -1-  .
    G15152751Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Locking cable

    1. 7.1  Loosen ball socket -2-  .
    2. 7.2  Unscrew screws on locking cable holder -3-  .
    3. 7.3  Remove locking cable -1-  together with holder.
scientia non olet · About LEMON Manuals