Test Conditions

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

Always pay particular attention to the following before raising the vehicle:

The levelling system must be deactivated before raising the vehicle (the levelling system button must be pressed and held for at least 10 seconds).
If a transmission range has to be engaged while the vehicle is raised, the levelling system must first be deactivated using the PIWIS Tester:

To do this, >>Levelling system/PASM<<>>Drive links/checks<<>>Activate/deactivate levelling system (without wheel rotation detection)<< must be selected in the control unit overview.

The value "Deactivate levelling system (permanently)" must then be selected and the function performed by pressing "Start"/F8.

The levelling system must be reactivated when the work is complete:

To do this, >>Levelling system/PASM<<>>Drive links/checks<<>>Activate/deactivate levelling system (without wheel rotation detection)>> must be selected in the control unit overview.

The value "Activate levelling system" must then be selected and the function performed by pressing "Start"/F8.

All functions (e.g. bleeding/filling) of the PASM control unit are deactivated as soon as the levelling system has been deactivated using the function >>Activate/deactivate levelling system (without wheel rotation detection)<<.

Transmission must not be in limp-home mode.
Warm up transmission in lower load range. Switch all transmission ranges several times while doing so.
Read out the ATF temperature using the PIWIS Tester.
ATF temperature: 30 - 50°C.
Selector lever is in position P.
Parking brake actuated.
Test and filling process at idle speed.
Air conditioning and heating switched off.
The ATF temperature must not be higher than 30°C at the beginning of the test.
If the ATF temperature is higher than 30°C, let the transmission cool down.