Installing Fuel Tank

Installation is performed in reverse order. Pay particular attention to the following:
1. 1.1 Tighten screws securing fuel tank to the body.
  - Tightening torque 20 Nm (15 ftlb.)
2. 1.2 Tighten screws for stone guard.
  - Tightening torque 20 Nm (15 ftlb.)
3. 1.3 Tighten screws on tank filler neck holder.
  - Tightening torque 15 Nm (11 ftlb.)
4. 1.4 Tighten screws for heat shield on fuel tank.
  - Tightening torque 4 Nm (3 ftlb.)
5. 1.5 Tighten nuts for right heat shield.
  - Tightening torque 2.5 Nm (1.75 ftlb.)
6. 1.6 Tighten nuts for centre rear heat shield.
  - Tightening torque 20 Nm (15 ftlb.)