Preparing seat cross member

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2021 Porsche 718 Cayman, 2021 Porsche 718 Boxster, 2020 Porsche 718 Cayman, 2020 Porsche 718 Boxster, and 2019 Porsche 718 Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Preparing seat cross members

Information

Position the seat cross members with the seat installed.

Install the seat cross members and align with the seat.
1. 1.1 Secure the seat cross members in the installation position and remove the seat.
2. 1.2 Drill rivet holes in the marked areas -3;4- using a > Diameter 6.6 mm drill.
  
  Fig 1: Seat Cross Member Component Location
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  
  Drilling holes
Drill rivet holes in the marked area -7- using a > Diameter 6.6 mm drill.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Drilling holes
Drill rivet holes in the marked areas -11:12:13- using a > Diameter 6.6 mm drill.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Drilling holes
Prepare the connection areas of the seat cross members for bonding and riveting.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Preparing rear seat cross member

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Preparing front seat cross member