LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2022 >> 718 Boxster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (51 - Body Center, Roof, Frame) >> WM, 516819 Removing And Installing Dashboard Bracket >> Removing And Installing Dashboard Bracket

Removing And Installing Dashboard Bracket

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2021 Porsche 718 Cayman, 2021 Porsche 718 Boxster, 2020 Porsche 718 Cayman, 2020 Porsche 718 Boxster, and 2019 Porsche 718 Cayman. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect electric wire harness for dashboard.
    1. 1.1  Disconnect electric plug connections at connection point on left A-pillar.
      1. 1.1.1  Release electric plug connections at the left fuse box -arrows A-  and guide them out -arrows B-  .
      2. 1.1.2  Release electric plug connections -arrow a-  and disconnect them -arrow C-. 
        G14270592Courtesy of PORSCHE CARS NORTH AMERICA, INC.

        Releasing and pulling off electric plug connections

    2. 1.2  Loosen clips -1-  on wire harness for heating/fresh-air unit.
      G14270593Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Loosening clips

    3. 1.3  Disconnect electric plug connections at connection point on right A-pillar.
      1. 1.3.1  Release electric plug connections at the left fuse box -arrows A-  and guide them out -arrows B-. 
      2. 1.3.2  Release electric plug connections -arrow a-  and disconnect them -arrow C-. 
        G14270594Courtesy of PORSCHE CARS NORTH AMERICA, INC.

        Releasing and pulling off electric plug connections

    4. 1.4  Disconnect electric plug connection for blower power supply.
      1. 1.4.1  Release electric plug connection -arrow A-  and guide it out -arrow B-. 
      2. 1.4.2  Release electric plug connection at the locking lugs -arrows a-  and disconnect it -arrow C-  .
        G14270595Courtesy of PORSCHE CARS NORTH AMERICA, INC.

        Releasing and pulling off electric plug connection

  2. Loosen mounting for dashboard bracket.
    1. 2.1  Unscrew nuts -1-  .
      G14270596Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Unscrewing nuts

    2. 2.2  Unscrew and remove lower screw at the right of the tunnel -2-  .
    3. 2.3  Unscrew and remove outer screw -3-  .
    4. 2.4  Unscrew and remove side screws -1-  .
      G14270597Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Loosening dashboard bracket

    5. 2.5  Detach dashboard bracket from the body.
    6. 2.6  Unclip electric lines -1-  on the right side of the dashboard bracket -2-  .
      G14270598Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Releasing electric lines

    7. 2.7  Remove dashboard bracket by pulling it towards the passenger compartment.
  3. Installation Is performed in reverse order.
  4. Screw in and tighten side screws -1-  > Tightening torque 23 N.m (17 ft.lb) 
  5. Screw in and tighten lower screw at the right of the tunnel -2-  > Tightening torque 23 N.m (17 ft.lb) 
  6. Screw in and tighten outer screw -3-  > Tightening torque 23 N.m (17 ft.lb) 
    G14270599Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Securing dashboard bracket

  7. Screw in and tighten nuts -1-  . Tightening torque 8 N.m (6 ft.lb) 
    G14270600Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Screwing in and tightening nuts

scientia non olet · About LEMON Manuals