Preparing Connection Areas Of The Body For Installation
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2021 Porsche 718 Cayman, 2021 Porsche 718 Boxster, 2020 Porsche 718 Cayman, 2020 Porsche 718 Boxster, and 2019 Porsche 718 Cayman. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
- The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
- Do not begin bonding work until all materials and tools necessary for later repair work are available.
- Align the sealing surface and connections of the body.
- De-burr connection points and prepare them for welding.
- Prepare marked areas for welding and bonding.
Preparing connection areas of the body
Preparing connection areas of the body
Red Plug-welding/apply a full weld using inert gas without bonding Yellow Bonding + riveting Blue Bonding Green Resistance spot-welding + bonding