LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2022 >> 718 Boxster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (55 - Lids, Flaps) >> WM, 556119 Removing And Installing Servo Motor For Emergency Release >> Removing And Installing Servo Motor For Emergency Release

Removing And Installing Servo Motor For Emergency Release

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2021 Porsche 718 Cayman, 2021 Porsche 718 Boxster, 2020 Porsche 718 Cayman, 2020 Porsche 718 Boxster, and 2019 Porsche 718 Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Information 

Function test on front lock lower part:

Check that the bowden cable is clipped fully into the brackets provided.

Check that the electric plug connection is connected.

Check that front lock lower part disengages correctly.

  1. Unscrew and remove screws -1-  .
  2. Lift servo motor for emergency release and pull it up out of the retaining frame -arrow-  .
    G14271262Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Removing servo motor for emergency release

  3. Disconnect electrical plug connection.
  4. Disengage bowden cable and remove servo motor for emergency release.
  5. Installation is performed in reverse order.
  6. Carry out a function test.
scientia non olet · About LEMON Manuals