Removing And Installing Front Wing

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2021 Porsche 718 Cayman, 2021 Porsche 718 Boxster, 2020 Porsche 718 Cayman, 2020 Porsche 718 Boxster, and 2019 Porsche 718 Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Remove expansion rivets -1- and remove masking panel -2- from the front wing -3- .

Fig 1: Front Wing Component Location
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Removing masking panel
Unclip line bracket -4- from the front wing -1- and move electric wire harnesses aside.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Loosening electric wire harnesses
Unscrew nuts -5- .
Unscrew and remove screw -6- .
Remove expanding clip -7- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Loosening front wing at the A-pillar
Unscrew and remove screws -8- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Loosening front wing at the top
Unscrew nuts -9- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Loosening front wing at the bottom
Unscrew screw -10- and remove front wing -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Removing front wing
Installation is performed in reverse order. Pay particular attention to the following:
Tightening torque for nut on front wing: > Tightening torque 10 N.m (7.5 ft.lb)

Tightening torque for screw on front wing: > Tightening torque 10 N.m (7.5 ft.lb)