LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Taycan Turbo S >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> 87 Air Conditioning -- Y1A - TAYCAN (Y1A) >> WM, 872119 Removing And Installing Particle Sensor (Fine Dust Sensor) >> Removing Particle Sensor (Fine Dust Sensor)

Removing Particle Sensor (Fine Dust Sensor)

NOTE: Voltage peaks 
  • Risk of damage to electrical load or to the control unit 

    → Switch off ignition and keep transmitter key outside of the transmission range (at least 5 m).

    → Switch off electrical loads before disconnecting or removing them.

  1. Loosen particle sensor -1-  .
    1. 1.1 Unclip clip -2-  .
    2. 1.2 Unscrew and remove screws -3-  .
    3. 1.3 Pull particle sensor -1-  out of the holder -4-  .
    4. 1.4 Release and disconnect electric plug connection -5-  .
    5. 1.5 Set particle sensor -1-  aside.
    G15565710Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Particle sensor (fine dust sensor)

  2. Remove particle sensor -1-  .
    1. 2.1 Unscrew screw -2-  .
    2. 2.2 Remove hose -3-  together with particle sensor -1-  .
G15565711Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Particle sensor (fine dust sensor)

scientia non olet · About LEMON Manuals