Securing Rear Brake Calliper

Remove tie-wrap -2- and then remove rear brake calliper -1- . Make sure not to damage or bend the brake lines on the rear brake calliper.
Get another person to help by holding the brake calliper!

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rear brake calliper in wheel housing
Install rear brake calliper -1- with new screws.
1. 2.1 Position rear brake calliper -1- .
2. 2.2 Fit and tighten new screws -2- .
  > Tightening torque 30 Nm (22 ftlb.)
> Torque angle 75 °

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rear brake calliper
Clip in rear brake line -1- at holder -2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rear brake line
Secure electric line for brake pad wear indicator -1- to holder -2- .
1. 4.1 Clip electric line -1- into holder -2- .
2. 4.2 Connect and lock electric plug connection for brake pad wear indicator -3- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric line for ABS
Connect and lock electric plug connection for drive link for parking brake -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric plug connection for parking brake actuator