Repairing Antenna Cable In The Telephone Control Unit Area

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Antenna cable in telephone control unit area

1. 1.1  Unlock and pull off electric plug connections to telephone control unit -3-  .
2. 1.2  Detach tie-wrap -4-  .
3. 1.3  Disconnect damaged area of antenna cable -1-  .

   Information 

   Antenna cable with a multi-pin electric plug connection -2-  cannot be repaired. A repair wire harness must be -1-  used for this.

   The repair wire harness is routed up to the possible connection points for the affected antenna cables and repaired at the connection punts.

   Multi-pin connector -3-  must not be opened at plug lock -A-  . The connector is damaged when opened.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Repair wire harness for antenna cable

   Information 

   The specified disconnection points are recommendations for a possible area that enables disconnection and repair.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Antenna cable connection points

1. 2.1  On main wire harness -11-  at marked areas -A, B and C-  , wind up the sleeve. If necessary, the sleeve can also be wrapped at cutting areas -B-  or -C-  .
2. 2.2  Determine the associated antenna cables by performing a continuity test using the shielding and mark the antenna cables, paying attention to the pin assignment:
   • Disconnect LTE antenna 1 (front left bumper connection point) -6-  .
   • Disconnect LTE antenna 2 (rear shelf) -8-  .
   • Disconnect LTE antenna 4 (rear lid) -9-  .
   • Disconnect LTE antenna 3 connection point (mirror base) -7-  .
3. 2.3  Secure repair wire harness along the main wire harness and shorten it to the required lengths.

> 912841 REPAIRING ANTENNA CABLE 

1. 4.1  Push on the electric plug connections until you feel them lock.
2. 4.2  Secure antenna cable with a new  tie-wrap.