Subsequent Work
- Electric shock
- Short circuit
- Fire
- Explosion
→ Only appropriately trained and authorised persons are permitted to work on high-voltage vehicles and components.
→ Required qualification: High voltage technician or high voltage expert.
→ Observe national requirements and legislation for this work.
→ Always use insulated tools, e.g. > VAS 6883 - Insulated Tool Set when working on these components. Observe general warning notes for working on the high-voltage system.
> 2X00IN GENERAL WARNING NOTES FOR WORKING ON THE HIGH-VOLTAGE SYSTEM
- Install power electronics.
- Fasten electric motor with automatic transmission on the assembly support.
> 279213 FASTENING ELECTRIC MOTOR WITH AUTOMATIC TRANSMISSION ON THE ASSEMBLY SUPPORT
- Install automatic transmission (with electric motor).
> 373519 REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (WITH ELECTRIC MOTOR)
- Observe general warning notes for working on the high-voltage system.
> 2X00IN GENERAL WARNING NOTES FOR WORKING ON THE HIGH-VOLTAGE SYSTEM
- Installing rear axle
- Secure ground strap for battery.
- Perform potential equalization measurement.
> 2X00IN PERFORMING POTENTIAL EQUALIZATION MEASUREMENT (FOUR-WIRE MEASUREMENT)
- Refill coolant.
- Start the high-voltage system.
- Complete the required documentation for starting the high-voltage system.