Removing Control Unit For Distance Measuring Sensor

NOTE: NOTIFICATION
Voltage peaks

Risk of damage to electrical load or to the control unit
→ Switch off ignition and keep transmitter key outside of the transmission range (at least 5 m).

→ Switch off electrical loads before disconnecting or removing them.

Information

Always comply with the regulations for handling ESD-sensitive components!

Assembly work may only be carried out if the mechanic is wearing the working clothes and shoes approved by Porsche .
The new part must only be removed from the ESD (electrostatic discharge) protective packaging just before installation and at the position at which the part is to be installed .
The electrical pins or plug contacts must not be touched .

Loosen control unit for distance measuring sensor -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screws
1. 1.1 Unscrew and remove screws -2- .
2. 1.2 Unclip control unit for distance measuring sensor -1- with holder -3- and guide it out until the electric plug connection is accessible.
Release and disconnect electric plug connection -2- and unclip control unit for distance measuring sensor -1- from holder -3- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric plug connection
Remove control unit for distance measuring sensor.