Securing Main Wire Harness In Passenger Compartment At The Left
- Installation is performed in reverse order. Pay particular attention to the following:
Tighten nut securing holder to body to > Tightening torque 8 Nm (6 ftlb.) .
Tighten nuts securing grommet to body to > Tightening torque 8 Nm (6 ftlb.) .
Tighten nut securing ground point on A-pillar to body to > Tightening torque 9.5 Nm (7 ftlb.) .
Tighten nuts securing cable duct in front door sill to body to > Tightening torque 2.5 Nm (1.75 ftlb.) .
Tighten nuts securing cable duct in rear door sill to body to > Tightening torque 2.5 Nm (1.75 ftlb.) .
Tighten nut securing ground point on cross member in seat well to body to > Tightening torque 9.5 Nm (7 ftlb.) .
Electric plug connections must engage securely.