Subsequent Work

Only after installing the rear axle: 

1. Secure upper control arm (front) to wheel bearing housing.

   > 423519 REMOVING AND INSTALLING UPPER CONTROL ARM (FRONT) - information on "Installing".

2. Secure upper control arm (rear) to wheel bearing housing.

   > 423519 REMOVING AND INSTALLING UPPER CONTROL ARM (REAR) - information on "Installing".

3. Install rear wheel housing liner.

   > 536919 REMOVING AND INSTALLING REAR WHEEL HOUSING LINER - information on "Installing".

   Basically: 

4. Fit wheel.

   > 440519 REMOVING AND INSTALLING WHEEL - information on "Installing".

5. Position disc brake pads by pressing the brake pedal several times.
6. Check brake fluid level in the reservoir and correct it if necessary.