Installing Cover For Rear Backrest
NOTE:
NOTIFICATION
Risk of damage to cover if excessive heat is applied.
Risk of damage to cover if excessive heat is applied.
- Creases in cover
→ If creases have formed, only short partial warming with the hot-air gun is permissible.
→ The hot-air temperature of 50 °C must always be observed.
Information
- Use new cushion rings and engage them in the integrated metal strut of the cover.
- Fasten cover to the padding, starting at the inside.
- Installation is performed in reverse order. Pay particular attention to the following:
Fit cushion rings using > V.A.G 1634B - upholstery clip pliers .
If creases have formed, partially heat affected areas of the cover with the hot-air gun and smooth out the cover using special tools:
> 9747 - Wetting-off iron
> 9747/1 - Knurling iron
> 9747/2 - Bone burnisher
> V.A.G 1416 - Hot-air blower