Installing Number Plate Cover
CAUTION:
Possible malfunction of front assistance systems
- Number plate not fitted correctly.
→ Observe installation instructions for number plate covers.
→ Do not use additional number plate holders for mounting the front number plate.
→ Only fit the number plate within the specified periphery.
→ Make sure that the number plate is fitted flat on the specified contact surface.
Information
When fitting cover for the first time, the holes for the expansion rivets must be pre-drilled to > Diameter 6.5 mm .
- Installation is performed in reverse order. Pay particular attention to the following:
Position the number plate cover on the front apron using the cut-out as a guide.
Tighten screws on number plate to > Tightening torque 0.8 Nm (0.6 ftlb.) .