Fitting Rear Logo

Information

Carefully clean any dirt, grease, wax and other impurities off the fitting area of the body using isopropanol.
Always use a clean cloth.
The room and object temperature must be at least > Nominal value + 15 °C .
Air humidity must be > Nominal value 50 % +/- 10 % .
Do not touch the bonding surface again after removing the protective paper.
Wear clean gloves during the bonding process in order to guarantee adequate adhesion.
The parts must have been bonded for at least > Nominal value 72 h > before washing the vehicle in a car wash.

Information

To ensure that the logo template does not lose its shape, always store the logo template on the relevant support (packaging) after using it.

Position logo using logo template.