Installing Front Seat
Incorrect line routing
- Risk of damage to lines and hoses
- Malfunction and fault memory entry on control unit
→ Avoid small bending radii when routing lines.
→ File down edges and burrs in the routing area or mask them with adhesive tape.
→ Maintain a sufficient distance from components exposed to high temperatures while driving.
Information
The terms "Ignition on" and "Starting engine" are re-defined for fully electric vehicles (battery electric vehicles - BEV).
Establishing operational readiness/Ignition on:
Prerequisites for establishing operational readiness: High-voltage battery is sufficiently charged, remove vehicle charging cable from the vehicle charge port, put driver's key in the emergency start tray.
Establishing operational readiness automatically: Get into the vehicle and close the driver's door. The driver's key is recognized inside the vehicle. Operational readiness is established.
Establishing operational readiness manually: Press Start/Stop switch. The driver's key is recognized inside the vehicle. Operational readiness is established.
Establishing operational readiness/Starting engine:
Establish operational readiness and engage transmission range. The vehicle is now ready to drive and can be moved.
Ending operational readiness/Switching off ignition
Ending operational readiness automatically: Get out of the vehicle with the driver's key and close the driver door. The driver's key is no longer detected outside the vehicle. Operational readiness ends.
Ending operational readiness manually: Press Start/Stop switch until the instrument cluster is switched off.
Ending driving readiness/Stopping engine
Vehicle is stationary: Press the P button on the instrument cluster. The vehicle is parked.
Information
Fastening screws and fastening nuts must not be re-used and must be replaced with new ones.
- Danger of injury
- Loss of torque
→ Always use new screws or nuts following removal.
→ Comply with instructions for repairs.
→ Observe specified tightening torques.
→ Carry out a visual inspection of parts used.
- Installation is performed in reverse order.
- Replace
screws and tighten to the specified tightening torque.
Tighten screws to > Tightening torque 50 Nm (37 ftlb.) .
Tighten screws to > Tightening torque 50 Nm (37 ftlb.) .