Subsequent Work
- Only for vehicles with Business package (I-no. 3Z7):
Install rear display and operator control unit.
> 913119 REMOVING AND INSTALLING REAR DISPLAY AND OPERATOR CONTROL UNIT
- Install rear storage compartment and screw in and tighten screw -2-
> Tightening torque 1.5 Nm (1 ftlb.)
Screwing in screw
- Install rear climate control panel.
> WM, 881119 REMOVING AND INSTALLING REAR AIR-CONDITIONING SYSTEM REGULATOR
Information
If air jet was replaced, it must be taught using the PIWIS Tester.
- > 9900 - PIWIS Tester 3
must be connected. Then teach the air vent.
- 4.1 Select "Air conditioning" control unit.
- 4.2 Select "Maintenance and repairs".
- 4.3 Select and start "Teach: LIN automatic addressing".
- 4.4 Select and start "Alignment drive for LIN servo motors".
- 4.5 > 9900 - PIWIS Tester 3 must then be shut down and disconnected.