Replacing Power-Steering Gear

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Universal joint mounting

1. 1.1 Unscrew screw -2-  and replace it.
2. 1.2 Pull universal joint off the pin on the steering gear and slide it towards the steering column.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for front speed sensor

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for tie-rod ball on wheel bearing housing

1. 3.1 Unscrew nut -2-  on joint pin for the tie-rod ball as far as required so that it is flush with the upper edge of the joint pin.
2. 3.2 Press off joint pin for tie-rod ball using >T10187 - press-out tool. >Pressing off joint pin 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Pressing off joint pin

3. 3.3 Unscrew nut -2-  from joint pin for the tie-rod ball.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric connectors on power-steering gear

1. 4.1 Release and disconnect cable plug -3-  .
2. 4.2 Loosen bracket -4-  .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screw joint for secondary bearing on power-steering gear

1. 5.1 Unscrew screw -1-  and counter at the hexagon nut -2-  .
2. 5.2 Replace threaded connection.

Get another person to hold the power-steering gear.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for power-steering gear