Installing The Starter
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order.
- Screw in and tighten nut securing B+ line to starter > Tightening torque 23 Nm (17 ftlb.) +/- 10 %
- Screw in and tighten nut securing control line to starter > Tightening torque 9 Nm (6.5 ftlb.)
- Screw in and tighten screws > Tightening torque 45 Nm (33 ftlb.) + 10 % - 15 %