Vehicle Height With Steel Springs
WARNING: This page is about a different variant/trim than selected.
Information
- The following values refer to the DIN empty weight (DIN 70020), in other words: full fuel tank, vehicle with tyre sealant (or spare wheel, collapsible wheel) and tools, with no occupants and no luggage.
- Tyre pressure in accordance with specifications.
- On vehicles with air suspension, the vehicle must be adjusted to normal level using the Porsche System Tester. Only align and adjust the vehicle in this position.
- If the control unit or one of the level sensors was replaced, calibration must be carried out using the Porsche System Tester.
| Vehicle height | Steel springs |
|---|---|
| Front-axle height | |
| with 19, 20, 21 inch wheels [mm] | 414±10 |
| From outer wheel Centre to bottom edge of wing | |
| Rear-axle height | |
| with 19, 20, 21-inch wheels mm | 419±10 |
| From outer wheel Centre to bottom edge of wing | |
| Maximum difference in height, left to right: 10 mm |