Installing Throttle Housing
WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
- Install throttle housing -1-
.
- 1.1 Check that the seal is fitted correctly.
- 1.2 Move throttle housing -1-
into installation position and tighten screws -5-
.
> Tightening torque 7 Nm (5 ftlb.)
- 1.3 Plug in and lock electric connector -4- .
- 1.4 Connect and secure pressure hose -3-
.
> Tightening torque 5.5 Nm (4 ftlb.) +/- 0.5 Nm (0.4 ftlb.)
Throttle housing