Installing Primary Catalytic Converter (V6 MONOTURBO)

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Installation is performed in reverse order. Pay particular attention to the following:
1. 1.1 Fit new seal on exhaust turbocharger/primary catalytic converter flange.
2. 1.2 Fit new seal on primary catalytic converter/catalytic converter flange.
3. 1.3 Fit new nuts securing primary catalytic converter to catalytic converter.
4. 1.4 Fit new V-band clamp.
5. 1.5 Nuts securing primary catalytic converter to catalytic converter > Tightening torque 23 Nm (17 ftlb.) .
6. 1.6 Screw securing support to primary catalytic converter > Tightening torque 23 Nm (17 ftlb.) .
7. 1.7 V-band clamp > Tightening torque 7 Nm (5 ftlb.) +/- 1 Nm (0.5 ftlb.) .
8. 1.8 Screw on exhaust system holder > Tightening torque 23 Nm (17 ftlb.) .