Installing Front-Axle Support (Front Sections)

-2-  : > Tightening torque 55 Nm (41 ftlb.)  

-3-  : > Tightening torque 30 Nm (22 ftlb.)  

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for front-axle support (front section)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for add-on parts

1. 2.1 Tighten screws -1-  for oil lines > Tightening torque 6 Nm (4.5 ftlb.)  
2. 2.2 Tighten screws -2-  for oil line/oil cooler holders > Tightening torque 8 Nm (6 ftlb.)  
3. 2.3 If installed:  Fit expansion rivets -3-  for heat insulation. (Only at the right on petrol engines).