Installing Cover For Rear Backrest

WARNING: This page is about a different variant/trim than selected.

Installation is performed in reverse order.
Fit new cushion clips using > V.A.G 1634B - Cushion Clip Pliers .
NOTE:
Risk of damage to cover if excessive heat is applied.
- Creases in cover
  → If creases have formed, only short partial warming with the hot-air gun is permissible.
  
  → The hot-air temperature of 50°C must always be observed.
If creases have formed, partially heat affected areas of the cover with the hot-air gun and smooth out the cover using special tools:
> 9747 - Wetting-off iron

> 9747/1 - Knurling iron

> 9747/2 - Bone burnisher

> V.A.G 1416 - Hot-Air Blower