Installing Cover For Front Backrest
WARNING: This page is about a different variant/trim than selected.
NOTE:
Risk of damage to cover if excessive heat is applied.
- Creases in cover
→ If creases have formed, only short partial warming with the hot-air gun is permissible.
→ The hot-air temperature of 50°C must always be observed.
Information
- Replace upholstery rings and hang in integrated metal braces of the cover.
- Fasten cover to the padding, starting at the inside.
- Installation is performed in reverse order. Pay particular attention to the following:
Fit cushion rings using > V.A.G 1634B - Cushion Clip Pliers .
- If creases have formed, partially heat affected areas of the cover with the hot-air gun and smooth out the cover using special tools:
> 9747 - Wetting-off iron
> 9747/1 - Knurling iron
> 9747/2 - Bone burnisher
> V.A.G 1416 - Hot-Air Blower