LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 84 (6X Body-Equipment Outside-General - Wagon -- 971 - PANAMERA (971)) >> WM, 6X00IN30 Working With Adhesive Tape And Adhesive Pads >> Adhesive Tape And Adhesive Pads On The Bodywork >> Preparing Bonding Surfaces

Preparing Bonding Surfaces

WARNING: This page is about a different variant/trim than selected.

Initial cleaning 

Remove sticky, solid layers such as dirt, rust and old adhesive.

Cleaning 

Then clean the bonding flange areas using a lint-free cloth soaked in isopropanol until there are no more residues on the cloth.

Leave cleaned surfaces to dry off for 15 minutes; the bonding surfaces must be completely dry.

scientia non olet · About LEMON Manuals