Using Adhesive Set Components
WARNING: This page is about a different variant/trim than selected.
Information
Opened materials must be used up immediately and must not be re-used at a later time.
The following adhesive set components must be used, depending on the application. All other components must be disposed of professionally and in an environmentally friendly way.
Adhesive set components
| Application | New component without adhesive bead | Component with cut adhesive bead |
| Vehicle flange with repair paint finish without adhesive bead | -A, B-
- 2-component adhesive -C- - Mixing nozzle -D- - Cleaning cloths -E- - Applicator brush -F- - Primer |
-A, B-
- 2-component adhesive -C- - Mixing nozzle -D- - Cleaning cloths -E- - Applicator brush -F- - Primer -G- - Activator |
| Vehicle flange with cut adhesive bead | -A, B-
- 2-component adhesive -C- - Mixing nozzle -D- - Cleaning cloths -E- - Applicator brush -F- - Primer -G- - Activator |
-A, B-
- 2-component adhesive -C- - Mixing nozzle -D- - Cleaning cloths -E- - Applicator brush -G- - Activator |