Installing Front Window Guide
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order to removal.
- Tighten fastening screw on inside of front window guide to > Tightening torque 2.5 Nm (2 ftlb.) .
- Tighten fastening screws on outside of front window guide to > Tightening torque 2.5 Nm (2 ftlb.)
.
Information
The adhesive pad cannot be pulled off without damaging it and must always be replaced.
- Stick new adhesive pad on firmly.
- 4.1 Position adhesive pad so that the assembly opening is completely covered.
- 4.2 Press adhesive pad on firmly.