LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 81 (66 Exterior Equipment - Wagon -- 971 - PANAMERA (971)) >> WM, 664719 Removing And Installing Moulding For Rear Lid >> Installing Moulding For Rear Lid

Installing Moulding For Rear Lid

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order. Pay particular attention to the following:

    Tightening torque for screw on tailgate cover: > Tightening torque 4 Nm (3 ftlb.) 

    Tightening torque for screws on middle cover: > Tightening torque 4 Nm (3 ftlb.) 

scientia non olet · About LEMON Manuals