Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| Brake calliper to wheel bearing housing | M12/always replace screws or bolts following removal! | Initial tightening | 20 Nm (15 ftlb.) | ||
| Brake calliper to wheel bearing housing | M12/always replace screws or bolts following removal! | Final tightening | + 70° | ||
| Brake disc to wheel hub | Counters unk screw, M6 x 12 | Tightening torque | 5 Nm (3.5 ftlb.) |