Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance | Tolerance |
|---|---|---|---|---|---|
| Front upper control arm to wheel bearing housing | Hexagon-head bolt, M12 x 1.5 x 75 and hexagon nut/always replace bolts, and nuts following removal! | Initial tightening | 70 Nm (52 ftlb.) | ||
| Front upper control arm to wheel bearing housing | Hexagon-head bolt, M12 x 1.5 x 75 and hexagon nut/always replace bolts and nuts following removal! | Final tightening torque angle | + 90° | ||
| Front upper control arm to rear axle housing | Hexagon-head bolt, M12 x 1.5 x 75 and hexagon nut/always replace bolts and nuts following removal! | Initial tightening | 70 Nm (52 ftlb.) | ||
| Front upper control arm to rear axle housing | Hexagon-head bolt, M12 x 1.5 x 75 and hexagon nut/always replace bolts and nuts following removal! | Final tightening torque angle | + 90° | ||
| Rear upper control arm to wheel bearing housing | Hexagon-head bolt, M12 x 1.5 x 75 and hexagon nut/always replace bolts and nuts following removal! | Initial tightening | 70 Nm (52 ftlb.) | ||
| Rear upper control arm to wheel bearing housing | Hexagon-head bolt, M12 x 1.5 x 75 and hexagon nut/always replace bolts and nut; following removal! | Final tightening torque angle | + 90° | ||
| Rear upper control arm to rear axle housing | Hexagon-head bolt, M12 x 1.5 x 75 and hexagon nut/always replace bolts and nuts following removal! | Initial tightening | 70 Nm (52 ftlb.) | ||
| Rear upper control arm to rear axle housing | Hexagon-head bolt, M12 x 1.5 x 75 and hexagon nut/always replace bolts and nuts following removal! | Final tightening torque angle | + 90° |