Teaching While Driving

WARNING: This page is about a different variant/trim than selected.

A procedure in > 9900 - PIWIS Tester 3 can be used to teach the wheel IDs while driving: >>Tyre Pressure Monitoring (TPM) system <<>>Maintenance/repairs<<>>Teach wheel IDs<<>>Teach wheel IDs while driving<<.

The wheel IDs can also be taught without using the System Tester.

The following points must always be observed:

Allow an idle time of at least 5 minutes before teaching the wheel IDs (wheel electronics units are then in Sleep mode).
Briefly accelerate the vehicle to over 25 km/h (15 mph) in order to teach the wheel IDs (wheel electronics units are then in Burst mode).
Then continue driving at any speed (even < 25 km/h or 15 mph) for max. 10 minutes.
Teaching was successful if a pressure reading is displayed in the instrument cluster for all wheel positions.