LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (40 Wheel Suspension Front Drive Shaft 2.9L Turbo Hybrid -- 971 - PANAMERA (971)) >> WM, 400619 Removing And Installing The Front Axle Carrier >> Preliminary Work

Preliminary Work

WARNING: This page is about a different variant/trim than selected.
  1. Observe warning notes.

    > 2X00IN GENERAL WARNING NOTES FOR WORKING ON THE HIGH-VOLTAGE VEHICLE ELECTRICAL SYSTEM

  2. Isolate the high-voltage system from the power supply and complete the relevant documentation.

    > 2X00IN ISOLATING HIGH-VOLTAGE ELECTRICAL SYSTEM FROM POWER SUPPLY/STARTING HIGH-VOLTAGE ELECTRICAL SYSTEM

  3. Only for vehicles with PDCC:  Disconnect 48 V system.

    > 270703 DISCONNECTING AND STARTING 48 V SYSTEM

  4. Disconnect the battery.

    > WM, 270619 REMOVING AND REINSTALLING BATTERY

  5. Remove front wheels.

    > WM, 440519 REMOVING AND FITTING WHEEL

  6. Remove wheel housing liners on both sides of the vehicle.

    > WM, 505619 REMOVING AND INSTALLING FRONT WHEEL HOUSING LINER

  7. Remove front-axle support.

    > 400819 REMOVING AND INSTALLING FRONT-AXLE SUPPORT 

  8. Remove spring struts with drive shafts

    > Refer to the appropriate Service Information for Removing and installing front spring strut

    > 433019 REMOVING AND INSTALLING FRONT AIR-SPRING STRUT

  9. Support the engine on the body. (Engine safety device)

    > 1001IN SUPPORTING ENGINE ON THE BODY (ENGINE SAFETY DEVICE)

scientia non olet · About LEMON Manuals