Subsequent Work: Notes
- Secure pressure hoses at the bottom on both sides of the charge-air cooler.
> Tightening torque 5.5 Nm (4 ftlb.) +/- 0.5 Nm (0.3 ftlb.)
- V8 Turbo only:
Install air guide -1-
at the radiator frame.
- 2.1 Position air guide -2- and secure with clips.
Air guide at top of radiator frame
- Install air-cleaner cowl -1- .
- Secure intake scoops -1- .
- Install engine cover.
> 108319 REMOVING AND INSTALLING ENGINE COVER (DESIGN COVER) (V8 BITURBO)
> Refer to the appropriate Service Information for Removing and installing engine cover (design cover) (V6 biturbo)
- Install engine compartment trim panel.
> WM, 700219 REMOVING AND REINSTALLING FRONT TRIM PANEL (ENGINE COMPARTMENT) - Coupe or WM, 700219 REMOVING AND REINSTALLING FRONT TRIM PANEL (ENGINE COMPARTMENT) - Wagon
- Install front wheel housing liners.
> WM, 505619 REMOVING AND INSTALLING FRONT WHEEL HOUSING LINER
- Install rear cardan shaft.
- Secure ATF lines to the ATF cooler.
- Secure air-conditioning lines to the cooler.
> WM, 875019 REMOVING AND INSTALLING CONDENSER - Coupe or WM, 875019 REMOVING AND INSTALLING CONDENSER - Wagon
- Install exhaust system.
- Fill up coolant.
- Fill in refrigerant.
> WM, 870317 DRAINING AND FILLING REFRIGERANT R1234YF - Coupe or WM, 870317 DRAINING AND FILLING REFRIGERANT R1234YF - Wagon
- Check engine oil.
- Connect battery ground strap.
> 270619 REMOVING AND INSTALLING BATTERY
> Tightening torque 6 Nm (4.5 ftlb.)
- Fill in ATF.
- Perform suspension alignment.
- Perform a test drive.
After the cooling system has cooled down again, check the engine coolant level in the reservoir and top up to the Maximum mark if necessary.