Measuring Cylinder Bore
WARNING: This page is about a different variant/trim than selected.
- Using the cylinder gauge VAS 6078 , take measurements as shown > Diagram for measuring cylinder bore at three points in the cylinder, crosswise in transverse direction A and in longitudinal direction B .
Diagram for measuring cylinder bore
| 1 | 20-mm cylinder bore depth |
| 2 | 60-mm cylinder bore depth |
| 3 | 105-mm cylinder bore depth |
| Cylinder bore | New in mm | Maximum permitted deviation from nominal measurement in mm | Note |
|---|---|---|---|
| Nominal measurement | 86.01 ± 0.005 | Not determined | Measure at 20/60/105-mm cylinder bore depth. |